
Built in Austin

Austin building-envelope leak detection
Every AC line set, hose bib, and conduit is a hole in the weather plane. This site is those leaks — not windows, not vents, not a full recoating.
Homes, apartments, retail, offices, warehouses, and steel buildings across Greater Austin.
Mechanical and electrical punch a wall and leave foam or a smear of caulk. Rain finds it for years.
An AC line set on a south wall cooks the sealant. The stain shows up above a window that is not leaking.
Through-wall scuppers and overflow pipes that were never flashed become indoor waterfalls in a storm.

Built in Austin
What to watch for
Field standard
The field plan
Clear scope, honest boundaries, and a repair built around the assembly—not the stain.
We flash and rebuild the finish at wall penetrations so the pipe can move a little and water still sheds.
We do not re-run your mechanical. We make the hole honest: boot, flange, or soldered flashing, then a finish patch.
If the leak is the window or the bath vent, use those dedicated sites. This door stays on pipes, conduit, and fixtures.
Where we work
Focused field work for the assemblies that keep Central Texas properties dry, stable, and finished.

Openings, transitions, decks, walls, and exterior finishes—opened only as far as the evidence requires.
Documented conditions, defined responsibility, and repair scopes a superintendent can act on.
Straight answers
Yes, with the condenser running. We need access and a shutoff if we have to open the finish deep.
No. Foam is not flashing. We remove it when it is holding water.
Rated firestopping is its own trade. We will not stamp a firestop we did not install.
Request an Austin site visit
Share the address, when the condition appears, and a few useful photos. We’ll route it to the right field crew.
This request goes to Texas Rock Solid. Name the Austin penetration leaks job. Do not mention other trades on this page.